Adhesive - Design of Adhesive Joints

Design of Adhesive Joints

As a general design rule, the material properties of the object need to be greater than the forces anticipated during its use. (i.e. geometry, loads, etc.). The engineering work will consist of having a good model to evaluate the function. For most adhesive joints, this can be achieved using fracture mechanics. Concepts such as the stress concentration factor and the strain energy release rate can be used to predict failure. In such models, the behavior of the adhesive layer itself is neglected and only the adherents are considered.

Failure will also very much depend on the opening mode of the joint.

• Mode I is an opening or tensile mode where the loadings are normal to the crack.
• Mode II is a sliding or in-plane shear mode where the crack surfaces slide over one another in direction perpendicular to the leading edge of the crack. This is typically the mode for which the adhesive exhibits the highest resistance to fracture.
• Mode III is a tearing or antiplane shear mode.

As the loads are usually fixed, an acceptable design will result from combination of a material selection procedure and geometry modifications, if possible. In adhesively bonded structures, the global geometry and loads are fixed by structural considerations and the design procedure focuses on the material properties of the adhesive and on local changes on the geometry.

Increasing the joint resistance is usually obtained by designing its geometry so that:

• The bonded zone is large
• It is mainly loaded in mode II
• Stable crack propagation will follow the appearance of a local failure.