PETN - Explosive Use

Explosive Use

The most common use of PETN is as an explosive with high brisance. It is more difficult to detonate than primary explosives, so dropping or igniting it will typically not cause an explosion (at atmospheric pressure it is difficult to ignite and burns relatively slowly), but is more sensitive to shock and friction than other secondary explosives such as TNT or tetryl. Under certain conditions a deflagration to detonation transition can occur.

It is rarely used alone, but primarily used in booster and bursting charges of small caliber ammunition, in upper charges of detonators in some land mines and shells, and as the explosive core of detonation cord. PETN is the least stable of the common military explosives, but can be stored without significant deterioration for longer than nitroglycerin or nitrocellulose.

During World War II, PETN was most importantly used in exploding-bridgewire detonators for the atomic bombs. These exploding-bridgewire detonators gave more precise detonation, compared with primacord. PETN was used for these detonators because it was safer than primary explosives like lead azide: while it was sensitive, it would not detonate below a threshold amount of energy. Exploding bridgewires containing PETN remain used in current nuclear weapons. In spark detonators, PETN is used to avoid the need for primary explosives; the energy needed for a successful direct initiation of PETN by an electric spark ranges between 10–60 mJ.

Its basic explosion characteristics are:

• Explosion energy: 5810 kJ/kg (1390 kcal/kg), so 1 kg of PETN has the energy of 1.24 kg TNT.
• Detonation velocity: 8350 m/s (1.73 g/cm3), 7910 m/s (1.62 g/cm3), 7420 m/s (1.5 g/cm3), 8500 m/s (pressed in a steel tube)
• Volume of gases produced: 790 dm3/kg (other value: 768 dm3/kg)
• Explosion temperature: 4230 °C
• Oxygen balance: -6.31 atom -g/kg
• Melting point: 141.3 °C (pure), 140–141 °C (technical)
• Trauzl lead block test: 523 cm3 (other values: 500 cm3 when sealed with sand, or 560 cm3 when sealed with water)
• Critical diameter (minimal diameter of a rod that can sustain detonation propagation): 0.9 mm for PETN at 1 g/cm3, smaller for higher densities (other value: 1.5 mm)