Seismometer - Basic Principles

Basic Principles

Inertial seismometers have levers in them that keep rhythmic motion

• A weight, usually called the internal mass, that can move relative to the instrument frame, but is attached to it by a system (such as a spring) that will hold it fixed relative to the frame if there is no motion, and also damp out any motions once the motion of the frame stops.
• A means of recording the motion of the mass relative to the frame, or the force needed to keep it from moving.

Any motion of the ground moves the frame. The mass tends not to move because of its inertia, and by measuring the motion between the frame and the mass, the motion of the ground can be determined.

Early seismometers used optical levers or mechanical linkages to amplify the small motions involved, recording on soot-covered paper or photographic paper. Modern instruments use electronics. In some systems, the mass is held nearly motionless relative to the frame by an electronic negative feedback loop. The motion of the mass relative to the frame is measured, and the feedback loop applies a magnetic or electrostatic force to keep the mass nearly motionless. The voltage needed to produce this force is the output of the seismometer, which is recorded digitally. In other systems the weight is allowed to move, and its motion produces a voltage in a coil attached to the mass and moving through the magnetic field of a magnet attached to the frame. This design is often used in the geophones used in seismic surveys for oil and gas.

Professional seismic observatories usually have instruments measuring three axes: north-south, east-west, and the vertical. If only one axis can be measured, this is usually the vertical because it is less noisy and gives better records of some seismic waves.

The foundation of a seismic station is critical. A professional station is sometimes mounted on bedrock. The best mountings may be in deep boreholes, which avoid thermal effects, ground noise and tilting from weather and tides. Other instruments are often mounted in insulated enclosures on small buried piers of unreinforced concrete. Reinforcing rods and aggregates would distort the pier as the temperature changes. A site is always surveyed for ground noise with a temporary installation before pouring the pier and laying conduit. Originally, European seismographs were placed in a particular area after a destructive earthquake. Today, they are spread to provide appropriate coverage (in the case of weak-motion seismology) or concentrated in high-risk regions (strong-motion seismology).