Surveying - Surveying Techniques

Surveying Techniques

Historically, distances were measured using a variety of means, such as with chains having links of a known length, for instance a Gunter's chain, or measuring tapes made of steel or invar. To measure horizontal distances, these chains or tapes were pulled taut according to temperature, to reduce sagging and slack. Additionally, attempts to hold the measuring instrument level would be made. In instances of measuring up a slope, the surveyor might have to "break" (break chain) the measurement- use an increment less than the total length of the chain.

Historically, horizontal angles were measured using a compass, which would provide a magnetic bearing, from which deflections could be measured. This type of instrument was later improved, with more carefully scribed discs providing better angular resolution, as well as through mounting telescopes with reticles for more-precise sighting atop the disc (see theodolite). Additionally, levels and calibrated circles allowing measurement of vertical angles were added, along with verniers for measurement to a fraction of a degree—such as with a turn-of-the-century transit.

The simplest method for measuring height is with an altimeter – basically a barometer – using air pressure as an indication of height. But surveying requires greater precision. A variety of means, such as precise levels (also known as differential leveling), have been developed to do this. With precise leveling, a series of measurements between two points are taken using an instrument and a measuring rod. Differentials in height between the measurements are added and subtracted in a series to derive the net difference in elevation between the two endpoints of the series. With the advent of the Global Positioning System (GPS), elevation can also be derived with sophisticated satellite receivers, but usually with somewhat less accuracy than with traditional precise leveling. However, the accuracies may be similar if the traditional leveling would have to be run over a long distance.

Triangulation is another method of horizontal location made almost obsolete by GPS. With the triangulation method, distances, elevations and directions between objects at great distance from one another can be determined. Since the early days of surveying, this was the primary method of determining accurate positions of objects for topographic maps of large areas. A surveyor first needs to know the horizontal distance between two of the objects. Then the height, distances and angular position of other objects can be derived, as long as they are visible from one of the original objects. High-accuracy transits or theodolites were used for this work, and angles between objects were measured repeatedly for increased accuracy. See also Triangulation in three dimensions.

Turning is a term used when referring to moving the level to take an elevation shot in a different location. When land surveying, there may be trees or other obstructions blocking the view from the level gun to the level rod. In order to "turn" the level gun, one must first take a shot on the rod from the current location and record the elevation. Keeping the level rod in exactly the same location and elevation, one may move the level gun to a different location where the level rod is still visible. Record the new elevation seen from the new location of the level rod and use the difference in elevations to find the new elevation of the level gun. Turning is not only used when there are obstructions in the way, but also when drastically changing elevations. You can turn up or down in elevation but the gun must always be at a higher elevation than the base of the rod. A level rod can usually be raised up to 25 feet high, which enables the gun to be set much higher. However, if the gun is lower than the base of the rod, you will not be able to take a shot because the rod cannot be lowered beyond the ground elevation.